About installing Jenkins for DC/OS
As a package available in the Universe, Jenkins for DC/OS can be installed using either the web interface or the DC/OS CLI. With its sensible defaults, you can get up and running very quickly.
Note: Jenkins for DC/OS cannot be installed in
strict security mode.
Important: The default installation will use a
/tmp directory on the local host to store configuration and build data. This configuration will not scale to accommodate multiple Jenkins masters. In addition, it will result in the loss of data when the agent goes down. Before going into production, you must perform a custom install and set up either a shared file system (recommended) or pin to a single agent.
DC/OS 1.4 or later
Note: If you are on an earlier version and would like to try out Jenkins for DC/OS, contact firstname.lastname@example.org.
Installing Jenkins for DC/OS
Using the web interface
- Click Universe.
- Click the Install Package button for the Jenkins package.
To accept the default settings, click Install Package on the pop-up. To customize the installation parameters, click Advanced Installation instead. Refer to Customizing your install for more information about each option.
Using the CLI
Tip: To install Jenkins using the CLI, you must have the CLI installed.
From the CLI, type the following command to install Jenkins for DC/OS.
dcos package install jenkins
Note: You can use the
--options flag to pass custom configuration parameters. Refer to Customizing your install for more information.
Verifying your installation
- You can use either the web interface or the CLI to verify that Jenkins for DC/OS has installed successfully.
Launch your browser and navigate to the Jenkins interface at